GRAPHTEC FC7000 Series - When the Coordinate Axes Are Rotated after Moving the Origin Point

BASIC FUNCTIONS AND OPERATIONS: Moving the Origin Point
5-6
When the coordinate axes are rotated after moving the origin point
When the coordinate axes are rotated after the origin point is moved, the origin
point is reset as shown in the figure below. The distance “a” is retained, but the
distance “b” is reset.
• For the front loading model, rotate the above figure 180 degrees.
• When it is necessary to both move the origin and rotate the coordinate axes,
be sure to rotate the coordinate axes first.
• After a new origin point is set, the displayed coordinate values represent the
respective distances from the new origin.
Original origin point
New origin point
b
a
Before the settings were made After the settings were made
Original origin point
a
<When a cut sheet is loaded in the rear loading model>