ADVANCED FUNCTIONS AND OPERATIONS: Setting AUTO PRE FEED
6-4
CAUTION:• The FEED LENGTH setting is not linked to the PAGE LENGTH setting. To
make the effective cutting area longer, therefore, change the PAGE LENGTH
setting.
• When using roll media, either extend and load the length to be used before-
hand or use the media feed procedure (“5.4 Using the PRE FEED Function”,
“6.2 Setting AUTO PRE FEED”).
Beginning cutting or plotting without feeding the media first may generate a
position error or may cause the roll media to fall off the stock shaft.
This setting is retained in the plotter’s internal memory even when the power is
turned off.
MAKING THE SETTING AT THE FUNCTION 2 SCREEN
1Press the MENU key.
2Press the NEXT key until the following menu appears.
3Press the F4 key (FUNCTION 2). The following menu appears.
4Press the F3 key (AUTO PRE FEED). The following menu appears.
5 The asterisk “*” indicates the currently selected setting. Press the F3 key
(ENABLED) to select AUTO PRE FEED. Press the F4 key (DISABLED) if you
do not wish to use the AUTO PRE FEED function.
6Press the ENTER key to register your settings.
7 If ON was selected, the following FEED LENGTH setting menu appears.
8Use the (▲▼) POSITION keys to increase or decrease the value within the
range of 1 to 50 (m).
9Press the ENTER key to register your settings.
10 Press the MENU key to return the plotter to Ready status.
This setting is retained in the plotter’s internal memory even when the power is
turned off.
INTERFACE>
AREA PARAMETERS>
FUNCTION 1>
FUNCTION 2>
DATA SORTING>
AXIS ALIGNMENT>
AUTO PRE FEED>
TANGENT EMULATION>
AUTO PRE FEED
ENABLED
DISABLED*
AUTO PRE FEED
FEED LENGTH = 1 m
To Next Page
Loading...
