GRAPHTEC FC7000 Series - Setting the ORIGIN in HP-GL Mode; Setting Procedure

ADVANCED FUNCTIONS AND OPERATIONS: Setting the ORIGIN in HP-GL Mode
6-5
6.3 Setting the ORIGIN in HP-GL Mode
When the COMMAND setting is HP-GL, the origin point can be set to either the
lower left corner or center of the plotting area. When the COMMAND setting is GP-
GL, this parameter is not available.
SETTING PROCEDURE
1Press the MENU key.
2Press the NEXT key until the following menu appears.
3Press the F2 key (AREA PARAMETERS). The following menu appears.
Note: ORIGIN is only displayed when the COMMAND setting is HP-GL.
4Press the F1 key (ORIGIN). The following menu appears.
5 The asterisk “*” indicates the currently selected setting. Press the F3 key to
select LOWER LEFT. Press the F4 key to select CENTER.
6Press the ENTER key to register your settings.
7Press the MENU key to return the plotter to Ready status.
• This setting is retained in the plotter’s internal memory even when the power is
turned off.
• When the origin has been set to CENTER, the X- and Y-axis coordinate values
shown on the display panel represent the respective distances from the lower
left point of the effective cutting (plotting) area.
INTERFACE>
AREA PARAMETERS>
FUNCTION>
FUNCTION 2>
ORIGIN>
AREA>
EXPAND>
PAGE LENGTH>
ORIGIN POINT
LOWER LEFT*
CENTER