Chapter 9: TEST MODES AND
TROUBLESHOOTING
This chapter describes the check points and possible solu-
tions to use for troubleshooting.
Topics in this chapter
9.1 Using the Condition List Mode
9.2 Running the SELF TEST
9.3 Using the DATA DUMP mode
9.4 The Plotter Does Not Operate When Turned On
9.5 The Plotter Does Not Operate Correctly
9.6 The Cutting Results Are Unsatisfactory
9.7 Error Messages in GP-GL Command Mode
9.8 Error Messages in HP-GL Command Mode
To Next Page
Loading...
