GRAPHTEC FC7000 Series - The Position of the Origin Point

ADVANCED FUNCTIONS AND OPERATIONS: Auto Registration Mark Reading Function
6-19
With roll media, the registration marks must be at least 110 mm from the back
edge of the media.
The position of the origin point
After the registration marks are recognized, the drawing origin point is positioned
as shown below.
CAUTION: The drawing origin point specified by the application software must be moved if
required so that it matches the origin point of the registration marks.
You can measure the offset between the axis origin and the registration mark
using one of two methods.
• Read the numeric values (representing the distance from the axis origin to
the first registration mark) on the screen display of the software application.
• Plot the registration mark and then measure the distance from the origin
point.
22 15 22 15
Registration mark pattern 1
Media feed direction
Registration mark pattern 2
Right pinch
roller
Right pinch
roller
Left pinch roller
Left pinch roller
11020 11020
Registration mark pattern 1
Media feed direction
Registration mark pattern 2
Origin point
Origin point
Registration mark pattern 1
Media feed direction
Registration mark pattern 2
Origin point
Origin point