GRAPHTEC FC7000 Series - Hold-Down Force Assignments

Preparing to Cut: Aligning the Pinch Rollers
3 - 16
H
OLD-DOWN FORCE ASSIGNMENTS
Use the Strong setting for the pinch rollers used to hold down the edges of the
media. Always use the Weak setting for the pinch roller(s) between the two outside
rollers.
When two pinch rollers are used
When three pinch rollers are used
When four pinch rollers are used
OK
NG
Weak
Strong Strong
Weak
Strong Strong Weak Weak
OK
NG
Strong Weak Strong
Strong Strong Strong
Weak Weak Weak
Weak Strong Weak Weak Strong Strong
StrongStrong Weak
Weak Weak Strong
WeakWeakStrong
OK
NG
Strong Weak Weak StrongWeak Weak Weak Weak
All other combinations