GRAPHTEC FC7000 Series - Setting the RS-232 C Interface Transmission Conditions

INTERFACES: Setting the RS-232C Interface Transmission Conditions
10-6
10.5 Setting the RS-232C Interface Transmission
Conditions
SETTING PROCEDURE
1 Use either the INITIAL MENU or the MENU mode setting procedure described
in Section 10.3 “Interface Setting Menu” to display the following menu.Setting
Procedure
2Press the F3 key. The following menu appears
3Press the ENTER key to confirm the menu settings without making any
changes.
Press the F1 key to change the BAUD RATE.
Press the F2 key to change the DATA LENGTH.
Press the F3 key to change the PARITY BIT.
Press the F4 key to change the HANDSHAKING mode.
The blinking cursor moves to the selected setting.
4Use the (▲▼) POSITION keys to change the value for each of the settings.
Transmission speed selection: 19200, 9600, 4800, 2400, 1200, 600, 300 baud
Data length selection: 7 BIT, 8 BIT
Parity bit selection: NONE PARITY, EVEN PARITY, ODD PARITY
Handshaking mode selection: Hardwire, Xon/Xoff, Enq/Ack (when the
command setting is HP-GL)
Specify the same values as those used in the application.
5Press the ENTER key to register your settings. Press the NEXT key if you do
not wish to make any changes. The following menu appears.
6Press the MENU key to return the plotter to READY status.
STEP SIZE>
RS-232C>
COMMAND>
RS-0 9600 BAUD

8 BIT
NONE PARITY
HARDWIRE
STEP SIZE>
RS-232C>
COMMAND>