ADVANCED FUNCTIONS AND OPERATIONS: Specifying the Registration MARK SIZE
6-30
6.15 Specifying the Registration MARK SIZE
This function allows you to specify the size of the registration marks that are
printed on the media.
SETTING PROCEDURE
1Press the AXIS/R.M.S. key.
2 If the registration mark mode has been enabled, the following menu appears.
Note: If the registration mark mode has not been set, the axis alignment
menu screen appears. If you wish to use the registration mark functions,
press the NEXT key to cancel the operation and then refer to Section 6.12,
“Setting the Registration Mark Mode” for details on how to make the
registration mark mode settings.
3Press the F1 key (AUTO REG. MARK). The following menu appears.
Note: The following display can also be accessed from the INITIAL menu
screen that is displayed when the media set lever is not engaged.
Note: DISTANCE ADJUST is not displayed if media has not been loaded in
the plotter.
4Press the F3 key (OTHER SETUPS). The following menu appears.
5Press the F1 key (MARK SIZE). The following menu appears.
6Use the (▲▼) POSITION keys to increase or decrease the value in the range
from 5 to 20 (mm).
7Press the ENTER key to register your setting.
8Press the NEXT key to return the plotter to Ready status.
This setting is retained in the plotter’s internal memory even when the power is
turned off.
AUTO REG. MARK>
SKIP>
AUTO>
MANUAL>
MARK SCAN MODE>
MARK TYPE>
OTHER SETUPS>
DISTANCE ADJUST>
MARK SIZE>
SENSOR OFFSET ADJ.>
AXIS ORIGIN OFFSET>
PAPERWEIGHT>
MARK SIZE
15 mm
Input this length
To Next Page
Loading...
