GRAPHTEC FC7000 Series - Rotating the Coordinate Axes

ADVANCED FUNCTIONS AND OPERATIONS: Rotating the Coordinate Axes
6-13
6.7 Rotating the Coordinate Axes
This function is used to move the origin and rotate the coordinate axes by 90° as
shown in the figure below.
SETTING OPERATION
1Press the MENU key.
2Press the NEXT key until the following menu appears.
3Press the F3 key (FUNCTION 1). The following menu appears.
4Press the F2 key (ROTATE). The following menu appears.
5 The asterisk “*” indicates the currently selected setting. Press the F3 key (ON)
to enable rotation. To disable rotation, press the F4 key (OFF).
6Press the ENTER key to register your setting.
7Press the MENU key to return the plotter to Ready status.
This setting is retained in the plotter’s internal memory even when the power is
turned off.
Coordinates when OFF was
selected for ROTATE
Coordinates when ON
was selected for ROTATE
X
Y
Y
X
(Rear Loading)
X
Y
Y
X
(Front Loading)
Coordinates when ON
was selected for ROTATE
Coordinates when OFF
was selected for ROTATE
INTERFACE>
AREA PARAMETERS>
FUNCTION 1>
FUNCTION 2>
PREF. LINE TYPE>
ROTATE>
MIRROR>
SCALE>
ROTATE
ON
OFF*