GRAPHTEC FC7000 Series - Selecting a Function Menu; When the FC7000 Is in MENU Mode

Preparing to Cut: Selecting a Function Menu
3 - 4
3.2 Selecting a Function Menu
When the FC7000 is in MENU mode
When the plotter is in MENU mode (the MENU lamp is lit), each of the functions
listed below in the “Function Selection” column can be accessed by pressing the
NEXT key until the desired menu appears and then pressing the select key indi-
cated by a box.
Page Main menu Sub menu
ASSIGN PEN (2-pen model only)
INTERFACE
AREA PARAMETERS
FUNCTION 1
FUNCTION 2
CROSS CUT
PRE FEED
MOVE STEP
STEP SIZE (GP-GL only)
ORIGIN (HP-GL only)
ROTATE
PREF. LINE TYPE
DATA SORTING
RS-232C
COMMAND
AREA
PAGE LENGTH
EXPAND
SCALE
MIRROR
AXIS ALIGNMENT
AUTO FEED
TANGENT EMULATION
NEXT
NEXT
F1
FORCE
F2
SPEED
F3
QUALITY
F4
OFFSET
BACKGROUND
SETTINGS
OPTION 1
OPTION 2
PEN UP SPEED
OFFSET ANGLE
OFFSET FORCE
STEP PASS
NEXT
PEN OFFSET ADJ. (2-pen model only)
INITIAL DOWN FORCE
DISTANCE ADJUST
TEST
F3
QUALITY
F2
SPEED
PEN UP/DOWN
F1
FORCE
F4
OFFSET