GRAPHTEC FC7000 Series - Using the Condition List Mode

TEST MODES AND TROUBLESHOOTING: Using the Condition List Mode
9-2
9.1 Using the Condition List Mode
This function prints a list of the current plotter settings.
CAUTION: The pen carriage starts moving as soon as the CONDITION PRINT function is
selected. Do not place your hands or other objects on any moving parts.
SETTING PROCEDURE
1 Load paper larger than either ISO (A3) or Tabloid size (11” x 17”) in the plotter,
and mount a plotting pen.
2Press the MENU key.
3Press the NEXT key until the following menu appears.
4Press the F4 key (OPTION 2). The following menu appears.
5Press the F4 key (TEST). The following menu appears.
6Press the F2 key (CONDITION LIST). The following menu appears.
7 If a pen has not been mounted, mount a pen and then specify the conditions
for that pen. Press the F3 key to select DONE and start printing the
CONDITION LIST. If you do not wish to print the list, press the F4 key.
PEN UP/DOWN
BACKGROUND SETTINGS>
OPTION 1>
OPTION 2>
INITIAL DOWN FORCE>
DISTANCE ADJUST>
TEST>
CONDITION LIST>
SELF TEST>
DATA DUMP>
MOUNT THE PEN!
DONE>
CANCEL CONDITIONS>