ADVANCED FUNCTIONS AND OPERATIONS: Setting the AXIS ORIGIN OFFSET
6-33
6.17 Setting the AXIS ORIGIN OFFSET
Unless the origin point has been moved to a new location, it is always located at
the lower-left position. Use the AXIS ORIGIN OFFSET function when you wish to
move the origin point.
SETTING PROCEDURE
1Press the AXIS/R.M.S. key.
2 If the registration mark mode has been enabled, the following menu appears.
Note: If the registration mark mode has not been set, the axis alignment
menu screen appears. If you wish to use the registration mark functions,
press the NEXT key to cancel the operation and then refer to Section 6.12,
“Setting the Registration Mark Mode” for details on how to make the
registration mark mode settings.
3Press the F1 key (AUTO REG. MARK). The following menu appears.
Note: The following display can also be accessed from the INITIAL menu
screen that is displayed when the media set lever is not engaged.
Note: DISTANCE ADJUST is not displayed if media has not been loaded in
the plotter.
4Press the F3 key (OTHER SETUPS). The following menu appears.
AUTO REG. MARK>
SKIP>
AUTO>
MANUAL>
MARK SCAN MODE>
MARK TYPE>
OTHER SETUPS>
DISTANCE ADJUST>
MARK SIZE>
SENSOR OFFSET ADJ.>
AXIS ORIGIN OFFSET>
PAPER-WEIGHT>
Registration mark pattern 1
Media feed direction
Registration mark pattern 2
Origin point
Origin point
To Next Page
Loading...
