GRAPHTEC FC7000 Series - Setting Procedure; To Change the QUALITY

Pen Setting Conditions: Setting the Cutter-pen Conditions
4-6
S
ETTING PROCEDURE
1 Press the F1 to F4 key that corresponds to the number of the setting area (the
condition number) that you wish to change.
2Press the CONDITIONS key to display a conditions setting mode menu as
follows.
Note: The conditions that are actually displayed will vary according to the
selected cutter-pen condition setting area.
3Press the F2 key to change the SPEED setting. The location of the blinking
cursor indicates that you can change the F2 setting.
4Use the POSITION ( ▲▼) keys to select a value in the range specified below.
Specifiable range: 1 to 10, and from 15 to 105 (in increments of five)
5Press the ENTER key to register your setting. To exit the conditions setting
mode, press the NEXT key before pressing the ENTER key.
To Change the QUALITY
The QUALITY parameter sets the acceleration used for a cutting or a plotting
operation. Set the QUALITY value based on the guidelines in the table entitled
“Optimal Cutting Conditions for Each Media Type” and the table entitled
“Reference Pen Conditions for Plotting Pens” (See Section 4.1, “Pen Conditions”.)
SETTING PROCEDURE
1Press the F1 to F4 key that corresponds to the number of the setting area (the
condition number) that you wish to change.
2Press the CONDITIONS key to display a conditions setting mode menu as
follows.
Note: The conditions that are actually displayed will vary according to the
selected cutter-pen condition setting area.
SET 14

CONDITION 1 30
4
CB09Ux 0
SET 14
CONDITION 1 30
4
CB09Ux 0

SET 14 
CONDITION 1 30
4
CB09Ux 0