ADVANCED FUNCTIONS AND OPERATIONS: Selecting the Axis Alignment Method
6-41
6.21 Selecting the Axis Alignment Method
This function allows you to select the method for manual axis alignment. There are
three methods: 2-point alignment, 3-point alignment, and 4-point alignment. If 3-
point alignment or 4-point alignment is selected, distance correction can be
performed at the same time if distances are input at each point.
SELECTING THE AXIS ALIGNMENT METHOD
1Press the MENU key.
2Press the NEXT key until the following menu appears.
3Press the F4 key (FUNCTION 2). The following menu appears.
4Press the F2 key (AXIS ALIGNMENT). The following menu appears.
5Press the F3 key (METHOD). The following menu appears.
6 The asterisk “*” indicates the currently selected setting. Press the F2 key
(2POINTS) to perform 2-point alignment, the F3 key (3POINTS) to perform 3-
point alignment, or the F4 key (4POINTS) to perform 4-point alignment.
7Press the ENTER key to register your setting.
8Press the MENU key to return the plotter to Ready status.
This setting is retained in the plotter’s internal memory even when the power is
turned off.
INTERFACE>
AREA PARAMETERS>
FUNCTION 1>
FUNCTION 2>
DATA SORTING>
AXIS ALIGNMENT>
AUTO PRE FEED>
TANGENT EMULATION>
AXIS ALIGNMENT
METHOD>
TOOL>
AXIS ALIGNMENT
METHOD 2POINTS*
3POINTS
4POINTS
To Next Page
Loading...
