ADVANCED FUNCTIONS AND OPERATIONS: Setting the OFFSET FORCE
6-53
6.27 Setting the OFFSET FORCE
This function specifies the cutting force to be used to both perform a little cutting
and to position the cutter blade during initialization. At this time, the direction
faced by the cutter blade can also be controlled using a cutting force that is lower
than that used for normal cutting operations, so this function lets you
independently specify an offset cutting force.
Moreover, the cutting force specified here is also used as the cutting force for
tangential control of the cutter blade’s rotation.
SETTING PROCEDURE
1Press the MENU key.
2Press the NEXT key until the following menu appears.
3Press the F3 key (OPTION 1). The following menu appears.
4Press the F3 key (OFFSET FORCE). The following menu appears.
5Use the (▲▼) POSITION keys to increase or decrease the value in the range
from 1 to 31.
6Press the ENTER key to register your setting.
7Press the MENU key to return the plotter to Ready status.
This setting is retained in the plotter’s memory even when the power is turned
off.
PEN UP/DOWN>
BACKGROUND SETTINGS>
OPTION 1>
OPTION 2>
PEN UP SPEED>
OFFSET ANGLE>
OFFSET FORCE>
STEP PASS>
OFFSET FORCE
FORCE = 30
To Next Page
Loading...
