GRAPHTEC FC7000 Series - Loading Roll Media (Front Loading)

Preparing to Cut: Loading Media
3 - 10
4 Pull the media taut to make sure that there is no slack in the conveyance path,
and then raise the media set lever to lower the pinch rollers. Release the
media lock.
Loading Roll Media (Front Loading)
1 Lower the media set lever to raise the pinch rollers.
2 Place the media roll on the roll media stocker. Load the media in the plotter as
shown. Pass the leading edge from the front of the plotter so it emerges from
the back.
Media lock
Pinch roller