ADVANCED FUNCTIONS AND OPERATIONS: Setting Tangential Emulation
6-49
This setting is retained in the plotter’s internal memory even when the power is
turned off.
ENABLING/DISABLING TANGENTIAL EMULATION
1Press the MENU key.
2Press the NEXT key until the following menu appears.
3Press the F4 key (FUNCTION 2). The following menu appears.
4Press the F4 key (TANGENT EMULATION). The following menu appears.
5Press the F4 key (ENABLE/DISABLE). The following menu appears
6 The numbers at the right of CONDITION are the condition setting numbers 1 to
8. Use the ( ) POSITION keys to move the cursor to the number that you
wish to change the setting for. Use the (▲▼) POSITION keys to specify
ENABLE or DISABLE for each number. A √ mark appears under the number
when ENABLE has been selected for that number, and tangential control will
be performed for each of the specified condition numbers.
7Press the ENTER key to register your setting.
8Press the MENU key to return the plotter to Ready status.
• This setting is retained in the plotter’s internal memory even when the power is
turned off.
• When a cutter-pen condition number for which tangential control has been
enabled is selected, TANGENTIAL is displayed for that number on the Ready
status screen. This function cannot be used when PEN or POUNCE has been
selected.
INTERFACE>
AREA PARAMETERS>
FUNCTION 1>
FUNCTION 2>
DATA SORTING>
AXIS ALIGNMENT>
AUTO PRE FEED>
TANGENT EMULATION>
TANGENTIAL
EMULATION
MODE>
ENABLE/DISABLE>
TANGENTIAL EMULATION
CONDITION 12345678
-
▲
▼
To Next Page
Loading...
