GRAPHTEC FC7000 Series - Selecting Cutter-Pen Condition Setting Areas; Selection Method

Pen Setting Conditions: Selecting Cutter-Pen Condition Setting Areas
4-4
4.2 Selecting Cutter-Pen Condition Setting Areas
The cutter-pen conditions can be stored in eight setting areas numbered "1" to "8".
To set the cutter-pen conditions, first select the setting area (condition number).
Moreover, switching between the setting areas enables up to eight predefined
media types to be selected easily.
SELECTION METHOD
1 Press one of the F1 to F4 keys to select a group of previously-stored condition
settings.
2 If the F1 key is pressed when CONDITION 1 has been selected, the display
changes to CONDITION 5. If a condition number other than 1 was selected,
CONDITION 1 will be displayed when the F1 key is pressed. In the same way,
press F2 to select condition numbers 2 and 6, F3 to select condition numbers 3
and 7, and F4 to select condition numbers 4 and 8.
3 The selected cutter-pen condition settings will be used for the cutting
operation.