GRAPHTEC FC7000 Series - Setting the Mirror Mode; Setting Procedure

ADVANCED FUNCTIONS AND OPERATIONS: Setting the Mirror Mode
6-14
6.8 Setting the Mirror Mode
This function is used to cut a reversed image of the original data. In MIRROR
mode, the origin point and coordinate data are reversed as shown in the figure
below
SETTING PROCEDURE
1Press the MENU key.
2Press the NEXT key until the following menu appears.
3Press the F3 key (FUNCTION 1). The following menu appears.
4Press the F3 key (MIRROR). The following menu appears.
5 The asterisk “*” indicates the currently selected setting. Press the F3 key (ON)
to enable the MIRROR mode. To disable the MIRROR mode, press the F4
(OFF) key.
6Press the ENTER key to register your setting.
7Press the MENU key to return the plotter to Ready status.
This setting is retained in the plotter’s internal memory even when the power is
turned off.
INTERFACE>
AREA PARAMETERS>
FUNCTION 1>
FUNCTION 2>
PREF. LINE TYPE>
ROTATE>
MIRROR>
SCALE>
MIRROR
ON
OFF*
When OFF was selected
for MIRROR
When ON was selected
for MIRROR
X
Y
X
Y
<Rear Loading>
X
Y
X
Y
<Front Loading>
When ON was selected
for MIRROR
When OFF was selected
for MIRROR