INTERFACES: COMMAND Settings
10-7
10.6 COMMAND Settings
This function selects the command mode, either GP-GL or HP-GL. Be sure to set
the command mode to match the command mode setting of your software
application.
SETTING PROCEDURE
1 Use either the INITIAL MENU or the MENU mode setting procedure described
in Section 10.3 “Interface Setting Menu” to display the following menu.
2Press the F4 key. The following menu appears
3 The asterisk “*” represents the currently selected setting. Press the F3 key
(GP-GL) or the F4 key (HP-GL) to select the desired mode. The asterisk
appears next to the selected mode.
Press the ENTER key to register your setting and perform a reset operation.
STEP SIZE>
RS-232C>
COMMAND>
COMMAND
GP-GL*
HP-GL
To Next Page
Loading...
