GRAPHTEC FC7000 Series - Enlarging or Reducing an Image; Setting Procedure

ADVANCED FUNCTIONS AND OPERATIONS: Enlarging or Reducing an Image
6-15
6.9 Enlarging or Reducing an Image
This function sets the SCALE factor for enlarging or reducing an image to be cut or
plotted.
SETTING PROCEDURE
1Press the MENU key.
2Press the NEXT key until the following menu appears.
3Press the F3 key (FUNCTION 1). The following menu appears.
4Press the F4 key (SCALE). The following menu appears.
5Use the (▲▼) POSITION keys to select the desired scale factor within the
range of 1/8, 1/4, 1/2, 1, 2, 3, 4, 5, 6, 7, and 8.
6Press the ENTER key to register your setting.
7Press the MENU key to return the plotter to Ready status.
This setting is retained in the plotter’s internal memory even when the power is
turned off.
INTERFACE>
AREA PARAMETERS>
FUNCTION 1>
FUNCTION 2>
PREF. LINE TYPE>
ROTATE>
MIRROR>
SCALE>
SCALE
SCALE FACTOR = 1