GRAPHTEC FC7000 Series - Interface Setting Menu

INTERFACES: Interface Setting Menu
10-4
10.3 Interface Setting Menu
The interface functions can be set before or after loading the media.
USING THE INITIAL MENU TO SET THE FUNCTIONS
1 Lower the media set lever. The following menu appears.
2Press the F4 key (INITIAL MENU). The following menu appears.
3Press the F4 key (INTERFACE). The following menu appears.
4Press the F2 key to select STEP SIZE, the F3 key to select RS-232C, and the
F4 key to select COMMAND.
USING THE MENU MODE TO SET THE FUNCTIONS
1Press the MENU key.
2Press the NEXT key until the following menu appears.
3 Press the F1 key (INTERFACE). The following menu appears.
4 Press the F2 key to select STEP SIZE, the F3 key to select RS-232C, and the
F4 key to select COMMAND.
LOAD MEDIA
INITIAL MENU>
AUTO PRE FEED>
INITIAL FEED SPEED>
INTERFACE>
STEP SIZE>
RS-232C>
COMMAND>
INTERFACE>
AREA PARAMETERS>
FUNCTION 1>
FUNCTION 2>
STEP SIZE>
RS-232C>
COMMAND>