GRAPHTEC FC7000 Series - Using the HOLD Function

BASIC FUNCTIONS AND OPERATIONS: Using the HOLD Function
5-2
5.1 Using the HOLD Function
Press the HOLD key during a cutting or plotting operation to temporarily suspend
the cutting or plotting operation. While the operation is suspended, a selection
menu appears on the control panel display. Depending on the situation, select
whether to continue or to quit the operation.
SETTING PROCEDURE
1Press the HOLD key. The following menu appears.
2Press the F3 key (CONTINUE) to continue the suspended plotting or cutting
operation.
If the F4 key (QUIT) is pressed, the CLEAR BUFFER MEMORY menu shown
below appears.
3 Press the F3 key (CLEAR) to clear the buffer memory. If you don’t wish to clear
the buffer memory, press the F4 key (CANCEL) to return to the menu displayed
in Step 1.
4 If the F3 key (CLEAR) is pressed, the display changes as shown below.
5 The plotter returns to Ready status.
JOB IS INTERRUPTED
CONTINUE JOB>
QUIT JOB>
NOTE:
CONFIRM DATA FROM
MOST STOPPED.
BUFFER CLEAR OK?
CLEAR>
CANCEL>
CLEARING BUFFER!
PLEASE WAIT
BUFFER CLEAR
COMPLETED