OPTIONS: Pouncing Tool
7-5
Holder for auto registration mark sensor
Setting the pouncing conditions
This function specifies the interval between the holes used to create a continuous
punched outline.
SETTING PROCEDURE
1 Press the F1 to F4 key that corresponds to the number of the setting area (the
condition number) that you wish to change.
2Press the CONDITIONS key to display a conditions setting mode menu as
follows.
Note: The conditions that are actually displayed will vary according to the
selected cutter-pen condition setting area.
3Press the F4 key to display the blinking cursor at the position shown in the
following menu.
Use the (▲▼) POSITION keys to select POUNCE.
4Use the (▲▼) POSITION keys to increase the value in the range from 1 to 99
(mm).
5Press the ENTER key to register your setting. To exit the conditions setting
mode, press the NEXT key before pressing the ENTER key.
SET 14
CONDITION 1 30
4
CB09Ux 0
SET 14
CONDITION 1 30
4
POUNCE 1
To Next Page
Loading...
