Preparing to Cut: Turning on the Power
3 - 7
3.4 Turning on the Power
1 Make sure that the power switch is turned off (the " " side is pressed down).
2 Connect one end of the provided power cord to the FC7000 AC line inlet and
the other end to an electrical socket of the rated supply voltage. Make sure
that the FC7000 is grounded.
3 Turn on the FC7000 by pressing the "|" side of the switch. The control panel
POWER lamp lights.
4 If media has not been loaded, the firmware version number is displayed, fol-
lowed by a prompt to load media.
(The initial feed speed setting, interface settings and other parameter settings
can be made here).
LOAD MEDIA!
INITIAL MENU>
To Next Page
Loading...
