Out of the Box: Nomenclature
1 - 4
Rear View
Media set lever: ...........Used to raise or lower the pinch rollers during the loading
or unloading of media.
Pinch roller hold-down force switching lever:
Used to switch between the two pinch roller forces (strong
and weak).
AC line inlet: ................Inlet where the power cord is connected.
Media stocker: .............Used to carry roll media and ensure its proper rotation.
Stock rollers: ...............A media roll is placed on these rollers.
Media lock: ..................Used to prevent the stock rollers from rotating when the
media roll has been placed on top of them. The media
lock ensures that the media is pulled straight out from the
roll.
USB interface connector:
Used to connect the plotter to the computer with a USB
interface cable.
Serial interface connector:
Used to connect the plotter to the computer with an RS-
232 serial interface cable.
Media set lever
AC line inlet
Media stocker
Stock rollers
USB interface connector
RS-232C interface connector
Media lock
Pinch roller hold-down force switching lever
To Next Page
Loading...
