Out of the Box: Nomenclature
1 - 3
1.2 Nomenclature
Front View
Power switch: ..............Used to turn the plotter on and off.
Control panel: ..............Used to access various plotter functions.
Pinch rollers: ...............Rollers that push the media against the grit rollers.
Grit rollers: ..................Metallic rollers with a file-like surface that feed the media
back and forth.
Media sensors: ............The front sensor is used to sense the leading edge of the
media. The rear sensor is used to sense the trailing edge
of the media.
Pen carriage: ...............Moves the cutter-pen or plotting pen across the media
during cutting or plotting.
Pen holder: ..................Holds the cutter-pen or plotting pen and moves it up or
down.
Pen station (installed on 2-pen models only):
The second pen is mounted here.
Stand: .........................Used to make the plotter more portable and to free up
counter space
Grit roller position guide:
Stickers on the front of the Y rail and the rear side of the
top cover that show the position of each grit roller. Use
these alignment marks as an aid in locating the pinch roll-
ers.
Cutting groove: ............Used when cross-cutting is performed.
Cross-cutter unit: .........Used to perform cross-cutting of media so that the cut
length can be removed from the roll.
Grit roller
Media sensor
Power switch
Pinch roller
Pen carriage
Cross-cutter unit
Pen holder
Pinch rollers
Control panel
Stand
Cutting groove
Cutting mat
Grit roller position guide
Pen station
Grit roller
Media sensor
To Next Page
Loading...
