TEST MODES AND TROUBLESHOOTING: Running the SELF TEST
9-3
9.2 Running the SELF TEST
Your plotter is provided with a self-test function that enables it to plot a pattern and
check its own functions.
CAUTION: The pen carriage starts moving as soon as the CONDITION PRINT function is
selected. Do not place your hands or other objects on any moving parts.
SETTING PROCEDURE
1 Load paper larger than either ISO (A4) or letter size (8ā x 11ā) in the plotter,
and mount a plotting pen.
2Press the MENU key.
3Press the NEXT key until the following menu appears.
4Press the F4 key (OPTION 2). The following menu appears.
5Press the F4 key (TEST). The following menu appears.
6Press the F3 key (SELF TEST). The following menu appears.
7 If a pen has not been mounted, mount a pen and then specify the conditions
for that pen. Press the F3 key to select DONE and start plotting the SELF
TEST pattern. If you do not wish to plot the SELF TEST pattern, press the F4
key.
8 The plotter continues plotting the SELF TEST pattern until the power is
switched off. Turn off the power to exit the SELF TEST mode.
PEN UP/DOWN
BACKGROUND SETTINGS>
OPTION 1>
OPTION 2>
INITIAL DOWN FORCE>
DISTANCE ADJUST>
TEST>
CONDITION LIST>
SELF TEST>
DATA DUMP>
MOUNT THE PEN!
DONE>
CANCEL SELF TEST>
To Next Page
Loading...
