GRAPHTEC FC7000 Series - Withdrawing the Pen Carriage; Setting Procedure; Moving the Pen Carriage to the Origin Point

BASIC FUNCTIONS AND OPERATIONS: Withdrawing the Pen Carriage
5-3
5.2 Withdrawing the Pen Carriage
This function moves the pen carriage from its current position in +100-mm steps
along both the X and Y axes. Perform this operation when cutting or plotting has
been completed to enable you to easily check the results.
SETTING PROCEDURE
While holding down the ENTER key, press the (▲) POSITION key to withdraw the
pen carriage +100 mm in both the X and Y axes. Repeat this process as required
to further withdraw the pen carriage in +100-mm steps in both the X and Y axes.
For the front loading model, rotate the above figure 180 degrees.
5.3 Moving the Pen Carriage to the Origin Point
This function moves the pen carriage from its current position to the origin point.
SETTING PROCEDURE
While holding down the ENTER key, press the (▼ ) POSITION key to move the pen
carriage to the origin point
100mm
100mm
Pen carriage withdrawal position
Original pen carriage position (before withdrawal)
<When a cut sheet is loaded in the rear loading model>