ADVANCED FUNCTIONS AND OPERATIONS: Setting the DISTANCE ADJUSTMENT
6-32
If the F4 key (STANDARD) was selected, the distance between the registration
marks is rounded up or down to the nearest 5 mm, 10 mm, or 50 mm.
7Press the ENTER key to register your setting.
8 If CUSTOM was selected for DISTANCE ADJUST, the following screen is
displayed for selecting the distance adjustment divisor value.
When LENGTH UNIT is set to INCH:
To select the 5 mm distance adjustment divisor value (distances are
automatically rounded up or down to the nearest 5 mm), press the F2 key (5
mm RESOLUTION).
To select the 10 mm distance adjustment divisor value (distances are
automatically rounded up or down to the nearest 10 mm), press the F3 key (10
mm RESOLUTION).
To select the 50 mm distance adjustment divisor value (distances are
automatically rounded up or down to the nearest 50 mm), press the F4 key (50
mm RESOLUTION).
For INCH settings, select 0.25, 0.5, 0.75, 1, or 1.5 inches using the Up and
Down cursor keys.
9Press the ENTER key to register your setting.
10 Press the NEXT key to return the plotter to Ready status.
This setting is retained in the plotter’s internal memory even when the power is
turned off.
DISTANCE ADJUST
5mm RESOLUTION*
10mm RESOLUTION
50mm RESOLUTION
DISTANCE ADJUST
0.25inch RESOLUTION*
To Next Page
Loading...
