ADVANCED FUNCTIONS AND OPERATIONS: Setting the AXIS ORIGIN OFFSET
6-34
5Press the F3 key (AXIS ORIGIN OFFSET). The following menu appears.
6Press the F3 or F4 key to select the X or Y axis. Use the ( ) POSITION
keys to move the blinking cursor to the left or right, and the (▲▼) POSITION
keys to increase or decrease the value in the range from -200.0 to +200.0
(mm). Press the F2 key (+/-) to toggle the polarity.
7Press the ENTER key to register your setting.
8Press the NEXT key to return the plotter to Ready status.
This setting is retained in the plotter’s internal memory even when the power is
turned off.
AXIS ORIGIN OFFSET
+/- >
X= 00 .0mm
X= 000.0mm
0
▲
▼
X
Y
The desired
Origin Point
To Next Page
Loading...
