GRAPHTEC FC7000 Series - Page 125

ADVANCED FUNCTIONS AND OPERATIONS: AXIS ALIGNMENT Settings
6-45
1 Load a medium with a pre-printed image.
2 Specify Off for the registration mark mode (see Section 6.12, “Setting the
Registration Mark Mode”.
3 Select 3POINT for the axis alignment method (see Section 6.21, “Selecting the
Axis Alignment Method”).
4Press the AXIS/R.M.S. key. The following menu appears.
5Use the POSITION keys to move the pen carriage to Axis Point 1. The
displayed X- and Y-coordinate values represent the current pen carriage
position as X- and Y-axis offsets from the current origin.
6Press the ENTER key to register the setting. The following menu appears.
7Use the POSITION keys to move the pen carriage to Axis Point 2.
8Press the ENTER key to register the setting. The following menu appears.
9Use the POSITION keys to move the pen carriage to Axis Point 3.
10 Press the ENTER key to register the setting. The following menu appears.
11 To perform distance correction, use the POSITION keys to input the corrective
value for the distance between points 1 and 2. The measured value for the
distance between points 1 and 2 is shown in the 3rd row. Set the actual
distance in the 4th row. Use the (▲▼) POSITION keys to change the value.
Press the ENTER key to register your setting. If the value does not need to be
corrected, simply press the ENTER key. The following menu appears.
12 To perform distance correction, use the POSITION keys to input the corrective
value for the distance between points 1 and 3. The measured value for the
distance between points 1 and 3 is shown in the 3rd row. Set the actual
distance in the 4th row. Use the (▲▼) POSITION keys to change the value.
Press the ENTER key to register your setting. If the value does not need to be
corrected, simply press the ENTER key. The following menu appears.
13 Use the POSITION keys to move the pen carriage to the Axis Origin Point.
AXIS POINT 1
X= 0 mm
Y= 0 mm
AXIS POINT 2
X= 0 mm
Y= 0 mm
AXIS POINT 3
X= 0 mm
Y= 0 mm
DISTANCE
POINT 1-2
00099.8 mm
OK? 00100.0 mm
DISTANCE
POINT 1-3
00101.1 mm
OK? 00100.0 mm
AXIS ORIGIN POINT
X= 0 mm
Y= 0 mm