vi
Chapter 8: BACK GROUND SETTINGS
8.1 Description of the Background Settings .........................................................................................8-2
8.2 Setting the Background Settings ....................................................................................................8-5
Setting Procedure....................................................................................................................... 8-5
Chapter 9: TEST MODES AND TROUBLESHOOTING
9.1 Using the Condition List Mode ......................................................................................................9-2
Setting Procedure....................................................................................................................... 9-2
9.2 Running the SELF TEST ................................................................................................................9-3
Setting Procedure....................................................................................................................... 9-3
9.3 Using the DATA DUMP mode ......................................................................................................9-4
Setting Procedure....................................................................................................................... 9-4
9.4 The Plotter Does Not Operate When Turned On ...........................................................................9-5
9.5 The Plotter Does Not Operate Correctly ........................................................................................9-6
9.6 The Cutting Results Are Unsatisfactory .........................................................................................9-9
9.7 Error Messages in GP-GL Command Mode ................................................................................9-11
9.8 Error Messages in HP-GL Command Mode ................................................................................9-12
CAUSE .................................................................................................................................... 9-12
SOLUTION.............................................................................................................................. 9-12
Chapter 10: INTERFACES
10.1 RS-232C Interface ........................................................................................................................10-2
Factory Preset Settings............................................................................................................. 10-2
10.2 USB Interface Settings .................................................................................................................10-3
Supported Operating Systems.................................................................................................. 10-3
10.3 Interface Setting Menu .................................................................................................................10-4
Using the INITIAL MENU to set the functions ...................................................................... 10-4
Using the MENU MODE to set the functions ......................................................................... 10-4
10.4 Setting the STEP SIZE .................................................................................................................10-5
Setting Procedure..................................................................................................................... 10-5
10.5 Setting the RS-232C Interface Transmission Conditions .............................................................10-6
Setting Procedure..................................................................................................................... 10-6
10.6 COMMAND Settings ...................................................................................................................10-7
Setting Procedure..................................................................................................................... 10-7
Chapter 11: Specifications
11.1 Main Specifications ......................................................................................................................11-2
11.2 Options .........................................................................................................................................11-3
11.3 Supplies ........................................................................................................................................11-3
11.4 Menu Tree ....................................................................................................................................11-4
11.5 External Dimensions ....................................................................................................................11-5
FC7000-75 ..................................................................................................................................11-5
Optional stand and Basket Provided........................................................................................ 11-5
FC7000-100/130/160 .................................................................................................................11-6
To Next Page
Loading...
