Pen Setting Conditions: Adjusting the Blade Length
4-11
7 Turn the blade length adjustment knob in the clockwise direction to extend the
blade. Press the F4 key (CHECK) to coufirm direction of the cutter blade once
again. The current extended blade length is displayed. Continue to adjust the
blade length until it is extended sufficiently to enable cutting of thick media.
8Press the F2 key to start test cutting. Check the cut results when test cutting
has been completed.
BLADE ADJUST>
TEST 1>
TEST 2>
CUTTING PRO>
The blade is extended or retracted
approximately 0.5 mm with each turn.
The value is
decreased
The value is
increased
To Next Page
Loading...
