BASIC FUNCTIONS AND OPERATIONS: Using the COPY Function
5-9
If MIRROR is selected, the copies are cut in this sequence.
For the front loading model, rotate the above figure 180 degrees.
If ROTATE is selected, the copies are cut in this sequence.
For the front loading model, rotate the above figure 180 degrees.
Origin
Copy origin
Original cut
3rd copy
1st copy
2nd copy
4th copy
Copy space
Copy space
<When a cut sheet is loaded in the rear loading model>
Origin
Copy origin
1st copy
Original cut
2nd
copy
3rd
copy
4th copy
Copy space
Copy space
5th copy 6th copy
<When a cut sheet is loaded in the rear loading model>
To Next Page
Loading...
