ADVANCED FUNCTIONS AND OPERATIONS: Setting the Cutting/Plotting Area
6-8
When ROTATE has been selected to rotate the coordinate axes by 90° as
shown in the example below, the shaded area represents the effective cutting/
plotting area defined by the LL and UR points.
For the front loading model, rotate the above figure 180 degrees.
Upper-right point
Lower-left point
Origin
<When a cut sheet is loaded in the rear loading model>
X
Y
X
Upper-right point
Origin
Y
Lower-left point
<When a cut sheet is loaded in the rear loading model>
To Next Page
Loading...
