110
mount
Syntax
mount device
View
User view
Default Level
3: Manage level
Parameters
device: Name of a storage medium (for example cf).
Description
Use the mount command to mount a hot swappable storage medium, such as a CF
card, etc (excluding flash). This command is effective only when the device is in
unmounted state.
By default, a storage medium is automatically mounted and in the mounted state after
connected to the device. In other words, you can use it without mounting it.
Do not remove the storage medium or swap the board when mounting or unmounting
the device, or when you are processing files on the storage medium. Otherwise, the file
system could be damaged.
When a storage medium is connected to a lower version system, the system may not
be able to recognize the device automatically, and you must use the mount
command for the storage medium to function normally.
Before removing a mounted storage medium from the system, you must first unmount it
to avoid damaging the device.
Related commands: umount.
NOTE:
Support for this command depends on the device model.
Examples
Mount a CF card on the device.
<Sysname> mount cf:
% Mount cf: successfully.
%Apr 23 01:50:00:628 2008 Sysname VFS/0/LOG:
cf: mounted into slot 0.
To Next Page
Loading...
Need help?
General
