52
If you specify the parameters, you are prompted to enter the username and
password for accessing the FTP server.
The priority of the source address specified with this command is higher than that
with the ftp client source command. If you specify the source address with the ftp
client source command first and then with the ftp command, the source address
specified with the ftp command is used to communicate with the FTP server.
Related commands: ftp client source.
Examples
Log in from the current device Sysname1 to the device Sysname2 with the IP address of
192.168.0.211. The source IP address of the packets sent is 192.168.0.212.
<Sysname> ftp 192.168.0.211 source ip 192.168.0.212
Trying 192.168.0.211 ...
Press CTRL+K to abort
Connected to 192.168.0.211.
220 FTP Server ready.
User(192.168.0.211:(none)):abc
331 Password required for abc
Password:
230 User logged in.
[ftp]
ftp client source
Syntax
ftp client source { interface interface-type interface-number | ip source-ip-address }
undo ftp client source
View
System view
Default Level
2: System level
Parameters
interface interface-type interface-number: Source interface for the FTP connection,
including interface type and interface number. The primary IP address configured on
the source interface is the source IP address of the packets sent by FTP. If no primary IP
address is configured on the source interface, the connection fails.
ip source-ip-address: Source IP address of the FTP connection. It must be an IP address
that has been configured on the AC.
To Next Page
Loading...
Need help?
General
