H3C WX Series User Manual

189
command must be executed for multiple times to ensure normal startup of the HTTPS
service.
Related commands: display ip https.
Examples
Enable the HTTPS service.
<Sysname> system-view
[Sysname] ip https enable
ip https port
Syntax
ip https port port-number
undo ip https port
View
System view
Default Level
3: Manage level
Parameters
port-number: Port number of the HTTPS service, which ranges from 1 to 65535.
Description
Use the ip https port command to configure the port number of the HTTPS service.
Use the undo ip https port command to restore the default.
By default, the port number of the HTTPS service is 443.
This command does not check whether the configured port number conflicts with that
of an existing service. Therefore, you must ensure that the port number is not used by
another service before the configuration.
Related commands: display ip https.
Examples
Configure the port number of the HTTPS service as 6000.
<Sysname> system-view
[Sysname] ip https port 6000

H3C WX Series Specifications

General

Brand	H3C
Model	WX Series
Category	IP Access Controllers
Language	English