H3C WX Series User Manual

98
vt100: Specifies the terminal display type as VT100.
Description
Use the terminal type command to configure the type of terminal display under the
current user interface.
Use the undo terminal type command to restore the default.
By default, the terminal display type is ANSI.
The system supports two types of terminal display: ANSI and VT100. If the terminal
display of the device and the client (for example, hyper terminal or Telnet terminal) is
inconsistent or is set to ANSI, but the total number of the characters of the currently
using command line exceeds 80, anomalies such as cursor corruption or abnormal
display of the terminal display may occur on the client. Therefore, you are
recommended to set the display type of both the device and the client to VT100.
Examples
Set the terminal display type to VT100.
<Sysname> system-view
[Sysname] user-interface vty 0
[Sysname-ui-vty0] terminal type vt100
user privilege level
Syntax
user privilege level level
undo user privilege level
View
User interface view
Default Level
3: Manage level
Parameters
level: Command level in the range 0 to 3.

H3C WX Series Specifications

General

Brand	H3C
Model	WX Series
Category	IP Access Controllers
Language	English