H3C WX Series User Manual

192
Field
Description
Active
Number of patches in the ACTIVE state
Start-Address
Starting address of the memory patch area in the memory
patch active
Syntax
patch active patch-number
View
System view
Default Level
3: Manage level
Parameters
patch-number: Sequence number of a patch. The valid values of this argument
depend on the patch file used.
Description
Use the patch active command to activate the specified patch, namely, the system
will run the patch.
After you execute the command all the DEACTIVE patches before the specified patch
are activated.
The command is not applicable to patches in the DEACTIVE state.
After a system reboot, the original ACTIVE patches change to DEACTIVE, and become
invalid. To make them effective, you must activate them again.
Examples
Activate patch 3 and all the DEACTIVE patches before patch 3.
<Sysname> system-view
[Sysname] patch active 3
patch deactive
Syntax
patch deactive patch-number
View
System view

H3C WX Series Specifications

General

Brand	H3C
Model	WX Series
Category	IP Access Controllers
Language	English