194
[Sysname] patch delete 3 slot 5
patch install
Syntax
patch install patch-location
undo patch install
View
System view
Default Level
3: Manage level
Parameters
patch-location: A string consisting of 1 to 64 characters. It specifies the directory where
the patch file locates.
Description
Use the patch install command to install all the patches in one step.
Use the undo patch install to remove the patches.
After you execute the patch install command, the message Do you want to continue
running patches after reboot? [Y/N]: displays.
Entering y or Y: All the patches are installed, and turn to the RUNNING state from
IDLE. This equals execution of the commands patch location, patch load, patch
active, and patch run. The patches remain RUNNING after system reboot.
Entering n or N: All the patches are installed and turn to the ACTIVE state from IDLE.
This equals execution of the commands patch location, patch load and patch
active. The patches turn to the DEACTIVE state after system reboot.
Before executing the command, save the patch files to the root directory of the
device's storage medium.
The patch install command changes the patch file location specified with the
patch location command to the directory specified by the patch-location
argument of the patch install command. For example, if you execute the patch
location xxx command and then the patch install yyy command, the patch file
location automatically changes from xxx to yyy.
Examples
Specify the directory for the source patch files to the flash, and run the patches.
<Sysname> system-view
To Next Page
Loading...
Need help?
General
