H3C WX Series User Manual

78
[Sysname] user-interface vty 0
[Sysname-ui-vty0] authentication-mode password
[Sysname-ui-vty0] set authentication password cipher 321
Example 3:
Set to use username and password authentication when users use VTY 0 interface to
log onto the device. The username is 123 and the authentication password is 321.
<Sysname> system-view
[Sysname] user-interface vty 0
[Sysname-ui-vty0] authentication-mode scheme
[Sysname-ui-vty0] quit
[Sysname] local-user 123
[Sysname-luser-123] password cipher 321
[Sysname-luser-123] authorization-attribute level 3
command accounting
Syntax
command accounting
undo command accounting
View
User interface view
Default Level
3: Manage level
Parameters
None
Description
Use the command accounting command to enable command accounting.
Use the undo command accounting command to restore the default.
By default, command accounting is disabled. The accounting server does not record
the commands that the users have executed.
If command accounting is enabled, every executed command is recorded on the
HWTACACS server.
If both command accounting and command authorization are enabled, only the
authorized and executed commands are recorded on the HWTACACS server.

H3C WX Series Specifications

General

Brand	H3C
Model	WX Series
Category	IP Access Controllers
Language	English