H3C WX Series User Manual

193
Default Level
3: Manage level
Parameters
patch-number: Sequence number of a patch. The valid values of this argument
depend on the patch file used.
Description
Use the patch deactive command to stop running the specified patch and all the
ACTIVE patches after the specified patch, and the system will run at the original
software version.
This command is not applicable to the patches in the RUNNING state.
Examples
Stop running patch 3 and all the ACTIVE patches after patch 3.
<Sysname> system-view
[Sysname] patch deactive 3
patch delete
Syntax
patch delete patch-number
View
System view
Default Level
3: Manage level
Parameters
patch-number: Sequence number of a patch. The valid values of this argument
depend on the patch file used.
Description
Use the patch delete command to delete the specified patch and all the patches after
the specified patch.
This command only removes the patches from the memory patch area, and it does not
delete them from the storage medium. The patches are in the IDLE state after
execution of this command.
Examples
Delete patch 3 and all the patches after patch 3.
<Sysname> system-view

H3C WX Series Specifications

General

Brand	H3C
Model	WX Series
Category	IP Access Controllers
Language	English