H3C WX Series User Manual

172
View
Any view
Default Level
1: Monitor level
Parameters
by-linenum: Specifies to display the number of each line.
Description
Use the display this command to display the validated configuration information under
the current view.
After finishing a set of configurations under a view, you can use the display this
command to check whether the configuration takes effect.
A parameter is not displayed if it has the default configuration.
A parameter is not displayed if the configuration has not taken effect.
Execution of this command in any user interface view displays the valid configuration in
all the user interfaces.
Execution of this command in any VLAN view displays the configurations of all the
created VLANs.
Examples
Display the valid configuration information of the current view (the output information
depends on the current configuration of the AC).
<Sysname> system-view
[Sysname] user-interface vty 0
[Sysname-ui-vty0] display this
#
user-interface vty 0
history-command max-size 256
user-interface vty 1 4
#
return
display version
Syntax
display version
View
Any view

H3C WX Series Specifications

General

Brand	H3C
Model	WX Series
Category	IP Access Controllers
Language	English