H3C WX Series

80
undo databits
View
User interface view
Default Level
2: System level
Parameters
5: Five data bits for each character.
6: Six data bits for each character.
7: Seven data bits for each character.
8: Eight data bits for each character.
Description
Use the databits command to set data bits for the user interface.
Use the undo databits command to restore the default.
By default, the data bit is eight.
NOTE:
 The command is only applicable to asynchronous serial interfaces (including AUX and
console ports).
 The data bits setting on the terminal must be the same as that on the device user interface
for communication.
Examples
Set data bits to 5.
<Sysname> system-view
[Sysname] user-interface aux 0
[Sysname-ui-aux0] databits 5
display history-command
Syntax
display history-command
View
Any view
Default Level
1: Monitor level