170
regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to
256 characters. This argument is case-sensitive and can have spaces included.
Description
Use the display current-configuration command to display the current validated
configuration of an AC.
You can use the display current-configuration command to view the currently
validated configuration. A parameter is not displayed if it has the default configuration.
If the validated parameter is changed, although you have configured it, the validated
parameter is displayed. For example, ip address 11.11.11.11 24 has been configured on
a Loopback interface. In this case, if you execute the display current-configuration
command, ip address 11.11.11.11 255.255.255.255 is displayed, meaning the validated
subnet mask is 32 bits.
Related commands: save, reset saved-configuration, and display saved-configuration
(File Management in the Fundamentals Command Reference).
Examples
Display the configuration from the line containing “user-interface” to the last line in the
current validated configuration (the output information depends on the AC model and
the current configuration).
<Sysname> display current-configuration | begin user-interface
user-interface aux 0
user-interface vty 0 4
authentication-mode none
user privilege level 3
#
return
display diagnostic-information
Syntax
display diagnostic-information
View
Any view
Default Level
1: Monitor level
Parameters
None
To Next Page
Loading...
Need help?
General
