H3C WX Series User Manual

97
Default Level
2: System level
Parameters
1: 1 stop bit.
1.5: 1.5 stop bits.
2: 2 stop bits.
Description
Use the stopbits command to set the stop bits.
Use the undo stopbits command to restore the default.
By default, the stop bit is one.
NOTE:
 The WX series access controllers do not support the stop bits of 1.5.
 The command is only applicable to asynchronous serial interfaces (including AUX and
console ports).
 The stop bits setting on the terminal must be the same as that on the device user interface for
communication.
Examples
Set the stop bits to 1.5.
<Sysname> system-view
[Sysname] user-interface aux 0
[Sysname-ui-aux0] stopbits 1.5
terminal type
Syntax
terminal type { ansi | vt100 }
undo terminal type
View
User interface view
Default Level
2: System level
Parameters
ansi: Specifies the terminal display type as ANSI.

H3C WX Series Specifications

General

Brand	H3C
Model	WX Series
Category	IP Access Controllers
Language	English