H3C WX Series User Manual

32
undo sysname
View
System view
Default Level
2: System level
Parameters
string: System name of the access controller, a string of 1 to 30 characters. The system
default is H3C.
Description
Use the sysname command to set the system name for the access controller.
Use the undo sysname command to revert to the default system name.
The CLI prompt reflects the system name of an access controller. For example, if the
system name of an access controller is H3C, then the prompt of user view is <H3C>.
Examples
Set the system name of the access controller to ABC.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] sysname ABC
[ABC]
telnet
Syntax
telnet remote-host [ service-port ] [ source { interface interface-type interface-number
| ip ip-address } ]
View
User view
Default Level
0: Visit level
Parameters
remote-host: IPv4 address or host name of a remote system, a string of 1 to 20
characters, case insensitive.
service-port: TCP port number for the remote system to provide Telnet services. It ranges
from 0 to 65535 and defaults to 23
source: Specifies the source interface or source IPv4 address of Telnet packets.

H3C WX Series Specifications

General

Brand	H3C
Model	WX Series
Category	IP Access Controllers
Language	English