H3C WX Series User Manual

166
Examples
Set the name of the local time zone to Z5, five hours ahead of UTC time.
<Sysname> system-view
[Sysname] clock timezone z5 add 5
configure-user count
Syntax
configure-user count number
undo configure-user count
View
System view
Default Level
2: System level
Parameters
number: Number of users, the value range varies with ACs.
Description
Use the configure-user count command to configure the number of users allowed to
enter system view at the same time.
Use the undo configure-user count command to restore the default.
Two users are allowed to configure in system view by default.
Related commands: display configure-user.
NOTE:
 When multiple users enter system view to configure certain attribute, only the last
configuration applies.
 When the number of users has already reached the limit, other users cannot enter system
view.
Examples
Configure the limit of users as 4.
<Sysname> system-view
[Sysname] configure-user count 4

H3C WX Series Specifications

General

Brand	H3C
Model	WX Series
Category	IP Access Controllers
Language	English